Search found 96 matches
- Wed Jul 19, 2017 7:31 pm
- Forum: Project Gallery
- Topic: Its a shame
- Replies: 6
- Views: 15190
Re: Its a shame
There are lots of interest in the Z cars still. That is probably the exception because of their history here in the USA
- Tue Aug 18, 2015 11:53 am
- Forum: Engine and Drivetrain
- Topic: problems with oil pressure on a 2tc engine with 3tc crank
- Replies: 6
- Views: 10696
Re: problems with oil pressure on a 2tc engine with 3tc cran
i read in my corolla book that at idle its supposed to be 4.5
- Wed Aug 05, 2015 10:12 pm
- Forum: Engine and Drivetrain
- Topic: Stock engine, need help with timing and other RPM Q's
- Replies: 8
- Views: 11983
Re: Stock engine, need help with optimal shift and other RPM
keep it under 6000
- Fri Jul 31, 2015 5:47 pm
- Forum: Gallery
- Topic: Post Toyota's that make you puke!
- Replies: 49
- Views: 91960
- Mon Jul 20, 2015 6:03 pm
- Forum: VENDORS, Shop and service.
- Topic: EUROEXPORTINC.COM
- Replies: 2
- Views: 11697
Re: EUROEXPORTINC.COM
I've bought plenty of parts for my current build. All I need now are pushrods and head studs. They offer two different diameter pushrods and I'm not sure which ones to get (stock size or 3/8").
- Tue Jul 07, 2015 6:52 pm
- Forum: Engine and Drivetrain
- Topic: EGR Block off plate needed...
- Replies: 1
- Views: 4676
Re: EGR Block off plate needed...
I used coins and JB Weld for mine.
- Tue Jun 30, 2015 4:02 pm
- Forum: Drift and Circle Track
- Topic: Norcal Rallycross and Rallysprint
- Replies: 1
- Views: 10112
Re: Norcal Rallycross and Rallysprint
man that looks fun
- Tue Jun 30, 2015 2:28 pm
- Forum: Engine and Drivetrain
- Topic: undersized cam bearings
- Replies: 6
- Views: 9934
Re: undersized cam bearings
Thanks Estebot but I'm in Houston. I ended up using some decent old bearings (#2 thru #5) from a spare block. I used the new Clevite #1 bearing but hit it with 500 grit for clearance and 3hours later it worked. Halleluya! It took a while because I was test fitting it frequently in between sand paper...
- Fri Jun 26, 2015 8:18 pm
- Forum: Engine and Drivetrain
- Topic: undersized cam bearings
- Replies: 6
- Views: 9934
Re: undersized cam bearings
my machinist did a terrible job with the cam bearings. they look like total crap. I bought a third set of cam bearings and installed them myself with ease and it took less than an hour. when I went to test fit the cam, BAM, still doesn't fit. So I decided to hit it with 1200 grit paper and WD40 to r...
- Wed Jun 17, 2015 9:21 pm
- Forum: New member introduction
- Topic: New memeber but not new to 3TC Garage
- Replies: 2
- Views: 5184
Re: New memeber but not new to 3TC Garage
COOL YO! WELCOME. GOT ANY PICS?