3TCGARAGE.COM

Hahah how many sets have you removed

Ok so I'm doing the super common DIY coilover conversion for my wagon. AE86 front strut casings, T3 camber plates, t3 weld on coilover sleeves and SW20 kyb AGX struts. My question is I didnt notice this but when I ordered the SW20 struts I ordered the slightly longer stroke rear struts. I'm not tryi...

AWESOME! You're the man!

Besides the cost, if you were converting to EFI why not switch over to a COP setup or a edis setup?

Any body? I know the visors are held on by the clips but I dont know how to get the clips in.

I just picked up a set of very minty rain visors. I have the clips that fit in the doors to hold them in place but I can't figure out how to get the rain visors in. Every time I mess with it the clips end up sticking out above the visors when they should be under it. Any ideas?

Do the TE72 vents still have the plastic rivet things on the under side?

Do you know if the front bumper brackets will work on a te72 wagon?

I haven't had a chance to pull that line off. I blew air threw the hard lines though. The tank definitely gargled, after i hooked the line back up to the new pump all i got was small air pulses. Not a single drop of fuel came out.

Heres my baby