lopez286 wrote:1- 80 to 81 toyota starlet rack and pinion
2-try to grab the intermediate shaft from the starlet, later you will need to modify
3-take the bushings if you cand with the brackets to hold them down
4-if you can grab the whole steering shaft that goes inside the steering colum this way all you have to do is remove the stering box and shaft out of the te27 and this one will slide ride in,
5-you can use the te27 tie rods
6-you will need to modify your cross member to acomodate the rack and pinion
Ya it's just a aw11 rack and ae86 column, no special shaft as the te27 is smaller than the 86 it all fit pretty easy.
I'm on the third or fourth Revision, if you have access to an 86 I would measure the distance of the rack from the control arms to ensure proper geometry from the get go.
I've moved mine a couple times to optimize geometry.
Good luck, it's pretty easy, and it makes the car much more enjoyable to drive.
Users browsing this forum: No registered users and 1 guest