Clutch for a 3tc with w50 tranny

[baldo]

So Im about to get a w50 already set up for a 3tc. So can I use the 3tc clutch? Is the input shaft splines the same?

[ulises_te72]

the shaft spines is bigger on the w50 tranny. Here is the lynk for the clutch you need...

http://www.euroexportinc.com/3tc/compet ... 1620c.html

Good Luck

[baldo]

So this will fit the 3tc pressure plate? I have been looking at some kits and they are bigger. This is my last question about it, I know more about engines than clutches and trannys. Thanks man!

[ulises_te72]

Yes, it will fit the pressure plate and flywheel.

[BrianGT]

the shaft spines is bigger on the w50 tranny. Here is the lynk for the clutch you need...

http://www.euroexportinc.com/3tc/compet ... 1620c.html

Good Luck

Thank you for that link! It's just what I need for my W58 to 2T/3T gearbox conversion.
Cheers.

[njccmd2002]

if you dont mind me asking, how was this tranny prepared?

adapter plate? because i have one with adapter plate, and wonder if the shaft would have to be shortened bacause of this...

[hemilove]

nope but they have told me to weld the 3tc bellhousing to the trans so it has more room to hold on too but I used the adapter plate and that clutch it works well just do a normal break in and your set