**Starter Doesnt Fit--Hitting 2TG Block?**

Moderators: BOBLOOK, AE25, pufito18

Post Reply
whit
Posts: 20
Joined: Thu Jun 20, 2013 1:42 am

**Starter Doesnt Fit--Hitting 2TG Block?**

Post by whit »

**CLICK LINK BELOW PLEASE**

CLICK HERE------> :arrow: http://japanesenostalgiccar.com/forum/f ... -2tg-block
AE25
Moderator
Posts: 129
Joined: Tue Jul 16, 2013 9:03 am
Location: Auckland NZ
Contact:

Re: **Starter Doesnt Fit--Hitting 2TG Block?**

Post by AE25 »

was this resolved whit?
there are two bolt patterns on the 2tg(eu). early 2tg had a narrow spacing which looks like your bellhousing but there is a reduction starter found on later 13T-U too with narrow spacing. the 2tgeu/3tgte use a wider spacing so will not interchange to the early 2tg bell.
The reduction gear starter motor sits above rather than below the hole in the backing plate. Is yours upside down?
Post Reply