The bearings from Australia didn't pan out (may come later).
I got the Nachi 6206nr bearing $10.00 and getting a sleeve made to make up the 6mm difference.
The first machine shop gave me a quote of $200. for the 1st sleeve & $250 for 4 or 5.
The second estimate said not over $100 and will get back to me for actual price for single & multiple sleeves.
I'm thinking if I get multiple sleeves made the average cost should be $20 to $30 each.
Anyone interested in getting a sleeve?
Noisy tranny (t50)
Moderators: BOBLOOK, AE25, pufito18
Re: Noisy tranny (t50)
Well.... the stock pipe the shop got was 10 thousandths too small, so he made a brass sleeve for $75.00 and put a roll pin in the case so the sleeve will stay centered.
- Attachments
-
- DSC05899.jpg (113.71 KiB) Viewed 7035 times
-
- DSC05896.jpg (163.68 KiB) Viewed 7035 times
-
- DSC05893.jpg (128 KiB) Viewed 7035 times
Re: Noisy tranny (t50)
I put over 500 miles this past weekend and the tranny runs like new....no noise!
