3TCGARAGE.COM

Posted: **Sat Mar 14, 2015 12:26 am**

The bearings from Australia didn't pan out (may come later).
I got the Nachi 6206nr bearing $10.00 and getting a sleeve made to make up the 6mm difference.
The first machine shop gave me a quote of $200. for the 1st sleeve & $250 for 4 or 5.
The second estimate said not over $100 and will get back to me for actual price for single & multiple sleeves.
I'm thinking if I get multiple sleeves made the average cost should be $20 to $30 each.

Anyone interested in getting a sleeve?

Posted: **Sat Mar 14, 2015 9:39 pm**

I would be!

Posted: **Mon Mar 30, 2015 4:51 pm**

Well.... the stock pipe the shop got was 10 thousandths too small, so he made a brass sleeve for $75.00 and put a roll pin in the case so the sleeve will stay centered.

Posted: **Wed Apr 01, 2015 10:01 pm**

I put over 500 miles this past weekend and the tranny runs like new....no noise!

Posted: **Thu Apr 02, 2015 4:23 pm**

great effort nice

3TCGARAGE.COM

Noisy tranny (t50)

Re: Noisy tranny (t50)

Re: Noisy tranny (t50)

Re: Noisy tranny (t50)

Re: Noisy tranny (t50)

Re: Noisy tranny (t50)