Page 1 of 1
Dummy distributor
Posted: Wed May 28, 2014 12:49 am
by Datzilla
Looking to put a crank trigger wheel in use, what's the best option for the distributor. I was thinking take the rotor cap off with the trigger and using a cut off wheel , cut it flush and make a cover plate to go where the cap was. The shaft is locked in place so it can still turn the oil pump. Right? Thanks in advanced!
Re: Dummy distributor
Posted: Wed May 28, 2014 4:52 am
by NME308
Assuming you will be using waste spark that should work well!
I have created a cam sync sensor with mine but cannot yet confirm its success as I have not yet reached fire up stage...
Cheers,
Jason
Re: Dummy distributor
Posted: Wed May 28, 2014 1:41 pm
by Toyota1515
NME308 wrote:Assuming you will be using waste spark that should work well!
I have created a cam sync sensor with mine but cannot yet confirm its success as I have not yet reached fire up stage...
Cheers,
Jason
It would work Jason as long as it is indexed ti the #1 it will work.
Re: Dummy distributor
Posted: Wed May 28, 2014 9:37 pm
by BOBLOOK
Re: Dummy distributor
Posted: Wed May 28, 2014 10:06 pm
by Datzilla
Cool, thanks ! Boblook what kind of fab skills did it take to make? Pretty easy?
Re: Dummy distributor
Posted: Thu May 29, 2014 6:36 pm
by BOBLOOK
Thats not my Art so can't tell you build is Sunray ( previous board moderator) hope he is fine ?
I would pickup an old dizzy and start improvising sometime you handier then you expect
Datzilla wrote:Cool, thanks ! Boblook what kind of fab skills did it take to make? Pretty easy?
Re: Dummy distributor
Posted: Fri May 30, 2014 10:08 pm
by Datzilla
I'm on it, if I had a full set of tools I could be dangerous! Haha!
Re: Dummy distributor
Posted: Sat May 31, 2014 8:18 am
by BOBLOOK
