Page 1 of 1
Te27 Ball Joints
Posted: Thu Jun 12, 2014 10:20 pm
by 72te27
Anyone have experience replacing ball joints on stamped control arms? My Toyota Chassis book says just replace the whole arm, but ball joints are relatively cheap. Can they be replaced using standard techniques with deforming the arm?
Re: Te27 Ball Joints
Posted: Fri Jun 13, 2014 8:19 am
by 1.8te27
I took an extra pair of control arms to be powder coated then after they were done straight to the local mechanic shop to have the new ball joints installed.
Re: Te27 Ball Joints
Posted: Fri Jun 13, 2014 3:46 pm
by 72te27
The only ball joints I can find are the Beck-Arnley or 555 brands from Rockauto, E-bay or Autozone. Is that what you used? Not sure if they are one in the same. Is that what you used?
Re: Te27 Ball Joints
Posted: Fri Jun 13, 2014 5:15 pm
by toyorotor
yes I did it to my te27 control arms, To remove the ball joint, remove the retaining clip and place the control arm on a vise. use a socket on the ball joint and with 2-3 solid hits it will come out.
To install leave new ball joint in freezer overnite, then install them the same way.
Re: Te27 Ball Joints
Posted: Sat Jun 14, 2014 3:26 am
by 1.8te27
72te27 wrote:The only ball joints I can find are the Beck-Arnley or 555 brands from Rockauto, E-bay or Autozone. Is that what you used? Not sure if they are one in the same. Is that what you used?
I used beck arnley
Re: Te27 Ball Joints
Posted: Sat Jun 14, 2014 4:12 am
by 72te27
Thank you for the responses, 1.8te27 and toyorotor. Much appreciated!