Page 1 of 1
2tgeu kp61 mont help
Posted: Tue Jul 01, 2014 5:47 am
by roydon
Hey guy was thinking of getting my engine months cut short to fit the rubber in between the engine and x-member mont as the 2tgeu fits bar no rubber. Has any done this. Or any other way. Any other tip would be helpful with this swap to.
Re: 2tgeu kp61 mont help
Posted: Tue Jul 01, 2014 6:10 am
by BOBLOOK
Or you can't find very tinny engine mount to install i can't remember back then guy was using fork lift truck engine mounts for therw low profile
Re: 2tgeu kp61 mont help
Posted: Thu Jul 03, 2014 5:45 am
by Toyota1515
you need the TE31 motor mount brackets, and motor mounts,
Re: 2tgeu kp61 mont help
Posted: Fri Jul 25, 2014 8:43 am
by AE25
so to confirm.. te3# engine brackets and rubbers bolt a T motor to the kp61 crossmember?
Re: 2tgeu kp61 mont help
Posted: Fri Jul 25, 2014 5:22 pm
by Toyota1515
AE25 wrote:so to confirm.. te3# engine brackets and rubbers bolt a T motor to the kp61 crossmember?
Yeap
BUT...
You will need to drill the brackets mount hole about an inch tours the back of the car (just enlarge the hole next to the bracket mount hole to the size of the mount hole) and install the mount in that new hole, cuz if you try to install the engine in the OEM bracket hole it will be too far back!
Re: 2tgeu kp61 mont help
Posted: Mon Aug 04, 2014 1:58 am
by AE25
any idea if te3 brackets are same as te2 or ta22?
Re: 2tgeu kp61 mont help
Posted: Tue Aug 05, 2014 12:42 am
by Toyota1515
AE25 wrote:any idea if te3 brackets are same as te2 or ta22?
TE2X yes they are the same TA22 dont know, as we never get those here in the States!