Page 1 of 6
					
				Ryan's TE31
				Posted: Sat Jul 06, 2013 12:47 am
				by skellington
				
			 
			
					
				Re: Ryan's TE31
				Posted: Sat Jul 06, 2013 12:56 am
				by skellington
				
			 
			
					
				Re: Ryan's TE31
				Posted: Sat Jul 06, 2013 1:06 am
				by skellington
				I dug into the engine. I wanted to make the original 2tc run as best I could make it. Looking at the insides made me think, the miles must have flipped over. adjusting valves:
 
Rebuild of asian carb:
 
New exhaust piping, cat, and muffler to replace the swiss cheese that was there.
 
 
Found some rust:
 
Wire wheeled it and slowed it down:
 
I got the car running perfect... but was WAY too rich at high RPM to pass CA smog.

 
			
					
				Re: Ryan's TE31
				Posted: Sat Jul 06, 2013 1:18 am
				by skellington
				
			 
			
					
				Re: Ryan's TE31
				Posted: Sat Jul 06, 2013 1:24 am
				by skellington
				I decided to do a new timing chain set, waterpump, thermostat, and give everything a good cleaning.
Start

Some High temp green paint? why not.
 
 
 
All put back in and purring like a kitten.

 
			
					
				Re: Ryan's TE31
				Posted: Sat Jul 06, 2013 1:36 am
				by skellington
				1/2 off day at the parts yard yeilded goodies:
2tc

T50

High ratio rear end
 
Calculated gearing:
 

MA61 14x7 set
 
 
 
Not sure if I will end up using this:
 

 
			
					
				Re: Ryan's TE31
				Posted: Sat Jul 06, 2013 1:49 am
				by skellington
				
			 
			
					
				Re: Ryan's TE31
				Posted: Sat Jul 06, 2013 1:53 am
				by skellington
				
			 
			
					
				Re: Ryan's TE31
				Posted: Sat Jul 06, 2013 1:59 am
				by skellington
				
			 
			
					
				Re: Ryan's TE31
				Posted: Sat Jul 06, 2013 3:20 am
				by pufito18
				nice  i  like  your  project