Page 1 of 2
tranny expert question for T50
Posted: Tue Mar 31, 2015 8:39 pm
by toyorotor
I have a T50 from an 81-82, I swapped the Tail shaft off an early T50 to move the shifter forward,
I got the transmission in the trunk of the car so I don't know if it was working correctly , Nothing seemed wrong when I opened it up... no metal shavings or grinded teeth.....
I installed it and now its grinding real bad to go into Reverse. But if I throw 3/4 then Reverse it goes
in fine. Anyone know what is going on?
Re: tranny expert question for T50
Posted: Thu Apr 02, 2015 4:26 pm
by BOBLOOK
Re: tranny expert question for T50
Posted: Thu Apr 02, 2015 5:29 pm
by toyorotor
yeah.... why?
Re: tranny expert question for T50
Posted: Thu Apr 02, 2015 5:55 pm
by BOBLOOK
Maybe differance in the lever
Is youre clutch releasing properly no air in the clutch cylinder ?? bleed or adjust !
Re: tranny expert question for T50
Posted: Thu Apr 02, 2015 7:16 pm
by toyorotor
Well the shift rods where changed over also. Everything was a direct swap. Converting it to a Early style
T50.
Someone else told me to check the clutch to make sure its engaging correct. Everything is pretty much new...Clutch/Plate/Bearing/Slave Cylinder..... I got under the car while someone step on the pedal and the slave came all the way out... I took the boot off the fork and saw the plates springs get flat.....
Re: tranny expert question for T50
Posted: Thu Apr 02, 2015 7:21 pm
by BOBLOOK
can you move the fork by hand ? before the release bearing touch the pressure plate ? how much plaiy to it has !
Re: tranny expert question for T50
Posted: Thu Apr 02, 2015 7:57 pm
by toyorotor
I don't think it had any play in it...Do I remove the Slave Cylinder and check the play?
Re: tranny expert question for T50
Posted: Thu Apr 02, 2015 8:10 pm
by BOBLOOK
NO check this method
Re: tranny expert question for T50
Posted: Fri Apr 03, 2015 3:27 am
by 73te27
Which fork are you using? Fork and slave has to match the bell.
Re: tranny expert question for T50
Posted: Fri Apr 03, 2015 5:44 am
by BOBLOOK
73te27 wrote:Which fork are you using? Fork and slave has to match the bell.
Same thing i was wondering
