Running Mikuni 44s
Posted: Mon Jul 27, 2015 12:35 am
Hey everyone I've recently picked up a pair of Mikuni 44s, a mikuni manifold, and T3 stacks. I've never messed around with side drafts and wanted to get some pointers before pulling off my 32/36 offenhauser setup.
My 3tc has some headwork, large valves, Norris 342 cam, the head was shaved so probably somewhere in the neighborhood of 10:1 compression. I also have dual valve springs, hardened push rods, a header and full exhaust.
I'm trying to figure out a baseline for jetting etc so I can hit the ground running when I get everything on.
I also need the linkage and a carb sync tool. I would like any references for online stores to buy jets and other parts from as well. Here are a few pics of my setup and some pics of what is under the jet covers.
Also, do I need to run a gasket between the carbs and stacks and what about between the manifold and the carbs?
Thanks for the help!
My 3tc has some headwork, large valves, Norris 342 cam, the head was shaved so probably somewhere in the neighborhood of 10:1 compression. I also have dual valve springs, hardened push rods, a header and full exhaust.
I'm trying to figure out a baseline for jetting etc so I can hit the ground running when I get everything on.
I also need the linkage and a carb sync tool. I would like any references for online stores to buy jets and other parts from as well. Here are a few pics of my setup and some pics of what is under the jet covers.
Also, do I need to run a gasket between the carbs and stacks and what about between the manifold and the carbs?
Thanks for the help!