3TCGARAGE.COM

I have a 80 corolla liftback automatic, Im looking to buy everything necessary to do a full swap over to the 5 speed manual, slave cylinder, pedal assembly, etc. Shoot me a message if you have ANY insight and materials

i have 3tc flywheel with mounting bolts for sale on this forum

How much you willing to spent for the full swap,I have one all together but I really don't looking to sell unless the offert is right.

Im willing to hear an offer. I understand its a lot that goes into it. So shoot me an offer

I got everything from starter to driveshaft for $500. Pedals, master, slave, hard lines, centerforce clutch, shifter, boot, flywheel, x-member, trans mount, fork, throw out bearing, all bolts. The only thing I recommend is a new pilot bearing, the old one is good but I dont like to reuse them once its been removed but its your choice.
Dont know where you are but I am on Oahu and wont ship this.
Best advice I can give you is if you ala carte parts, not everything is interchangeable. Shifters, drive shafts, starters, forks, slaves, etc.

Damn man Id buy that in a heartbeat but im in Colorado /:

i have a drive shaft and bell housing if that helps. bell housing is boxed and ready to ship I would just have to figure out the drive shaft box but im asking 50 for each plus shipping

Hi
I have the brake & clutch pedal and the fluid clutch line from the master cylinder to the transmission.
I can email or text you pics.
Im asking $90 (shipping included).

Look fudes, I either want another auto trans, or a full 5 or 4 speed manual set up. If you have it all Ill pay the shipping cost.