3TCGARAGE.COM

I have mikuni 40 MM carbs and Im looking for a linkage kit that will work with them.
Could I used a universal weber side draft kit? Just need some direction here.
Thanks

You can contact them see if the fit

http://www.ebay.com.au/itm/TWIN-DELLORT ... 0973716411

Any of the throttle levers that suit Weber or Dellorto will not fit onto the Mikuni/Solex PHH range. Weber and Dellorto have 7mm throttle shaft and Mikuni/Solex have 8mm.

Here is a picture of a set up on a Nissan L16 manifold and for a Redline 2T Manifold that gives you an idea of what can be done:



The Universal kit can be used as a basis for a balance bar arrangement but you would need to purchase the OEM Mikuni Throttle arm and spring bracket kits.

What manifold will they go on? Perhaps a centre pull cable kit?